2014-03-16 17:04:33.566222+01 by Dan Lyke 0 comments
A suggestion on Facebook that I check out Schmart Board for surface-mount soldering. Apparently they make surface-mount boards with long over-tinned traces, you put a small tip on the trace and chase the solder back up to the pin.
Everything I'm dealing with right now is either through-hole or on a carrier, but this looks super handy.
comments in ascending chronological order (reverse):
We will not edit your comments. However, we may delete your comments, or cause them to be hidden behind another link, if we feel they detract from the conversation. Commercial plugs are fine, if they are relevant to the conversation, and if you don't try to pretend to be a consumer. Annoying endorsements will be deleted if you're lucky, if you're not a whole bunch of people smarter and more articulate than you will ridicule you, and we will leave such ridicule in place.
Flutterby™ is a trademark claimed by
Dan Lyke for the web publications at www.flutterby.com and www.flutterby.net.